Battery Commissioning And Maintenance Procedure; Commissioning - PEUGEOT E1A Workshop Manual

Battery commissioning and maintenance procedure

Remark: the maintenance procedure is identical to the commissioning procedure
Important:
It is essential to use distilled water supplied by PEUGEOT MOTOCYCLES under P/N: 973582
The use of distilled water from another sources will destroy the battery.
It is forbidden to pour in distilled water before the end of charging.

Commissioning:

Ensure you have 3 litres of PEUGEOT distilled water, P/N: 973582.
• Connect the charge cable to the 230 V – 10/16 A mains.
• The charge lamp
• Press key "V" on the keypad there is a beep and hold until there is a second beep.
• Release the « V » key, a series of 3 beeps indicates the operation is to commence, the charge lamp
flashes.
• If it does not flash, repeat the operations more quickly.
The commissioning procedure has started and will take 10 to 15 minutes.
At the end of charging, the
Note:
From this point on, you may leave the machine connected to the mains for a period of 72 hours. Beyond this
time, you will have to repeat the procedure from the start.
• Disconnect the charging cable, the
add water to the battery.
• Open the maintenance cover with a Torx screwdriver and slowly pour in the distilled water (P/N:
973582) until the water runs out of the overflow under the scooter.
• Close and tighten the maintenance cover, the
commissioning.
• Wait for a minimum of 15 seconds before turning on the ignition.
Reproductions or translations, even parrtial, are forbidden without the written consent of Peugeot Motocycles
SERVICE AND COMMISSIONING PLAN
comes on with a beep, the battery lamp
lamps stay on indicating that water may be added to the battery.
lamps stay on. You now have a maximum of 30 minutes to
lamps go off indicating the end of
flashes
Page: 6