Pre-Assembly B: Frame, Platen, Straight Unit, B - Epson EU-T432 Technical Manual

Confidential

Pre-assembly B: Frame, platen, straight unit, B

Reassembly
Part name
step
1 Frame, platen
2 Lock lever assembly
C.B.B-tite (M2 × × × × 6)
3 Cover, fixed blade
4 Fixed blade
5 Spring, fixed blade
Shouldec (2 × × × × 6 × × × × 2)
6-4 Assembly and Disassembly
Install the lock lever assembly on the frame, platen, and secure it with a
× 1
screw.
C.B.B-tite (M2 × 6)
lock lever assembly
<Check>
Tightening torque: 294 to 343 mN•m {3.0 to 3.5 kg•cm}
Make sure that the screw does not skew during tightening.
Install the cover, fixed blade and the fixed blade on the frame, platen;
then secure them with shouldecs.
At this time, install the spring, fixed blade on one of the shouldecs, as
× 2
shown below.
spring, fixed blade
cover, fixed blade
frame, platen
<Check>
Tightening torque: 177 to 226 mN•m {1.8 to 2.3 kg•cm}
Make sure to install the fixed blade right-side-up.
Make sure that the dowels on the frame, platen fit securely into the holes
on the cover, fixed blade.
Make sure to install the spring, fixed blade in the correct position.
Assembly procedure
frame, platen
shouldecs
fixed blade
mounting dowels
Rev. A