Epson EU-T432 Technical Manual page 91

Confidential
Reassembly
Part name
step
C.B (M4 × × × × 16)
3
P. washer (4.3 × × × × 0.8 × × × × 8)
Collar, screw holder
4 Gear, frame open
assembly
P. washer
Conical S. washer-1L, 4 × 4
5 Plate, rotation stopper
H. nut (4)
C.B (M4 × × × × 16)
9
P. washer (4.3 × × × × 0.8 × × × × 8)
Collar, screw holder
Gear, frame open
assembly
Conical S. washer-1L, 4 × 4
Plate, rotation stopper
H. nut (4)
★
10
frame, paper supply
assembly
Rev. A
× 1
Attach a P. washer
× 1 × × × × 16) screw; then attach the screw to the frame, paper supply assembly
× 1
from out side.
With the flat side of the gear, frame open assembly facing to the frame
× 1 side, attach it to the C.B (M4 × × × × 16) attached in step 3 from inside of the
× 2
(4.3 × × × × 0.8 × × × × 8)
frame, paper supply assembly; sequently attach a P. washer
, four conical S. washer-1L, 4 (with each two of concave surfaces
8)
facing each other), and another P. washer
× 1
Attach the plate, rotation stopper to the P. washer attached in step 4 so
× 1
that the bent part of the plate, rotation stopper is fit into the square hole
on the frame, paper supply assembly; then secure it with an H. nut.
× 1
Perform steps 3 to 5 for the other side of the frame, paper supply
× 3
assembly.
× 1
× 1
× 1
× 1
<Check>
Tightening torque: 206 to 216 mN•m {2.1 to 2.2 kg•cm}
Apply Screw Lock Green (adhesive) to the H. nut and the C.B (M4 × × × × 16).
plate, rotation stopper
hexagonal nut (4)
p. washer (4.3 × 0.8 × 8)
square hole
Assembly procedure
(4.3 × × × × 0.8 × × × × 8)
conical S. washer-1L, 4
EU-T432 Technical Manual
and the collar, screw holder to a C.B (M4
(4.3 × × × × 0.8 × × × × 8)
to the screw.
gear, frame open assembly
p. washer (4.3 × 0.8 × 8)
square
hole
C.B (M4 × 16)
collar, screw holder
Assembly and Disassembly 6-31
(4.3 × × × × 0.8 × × × ×