Disassembly; Assembly - Epson EU-T432 Technical Manual

Confidential

Disassembly

For disassembly, follow the assembly procedures described in "Assembly" in reverse
sequence.
Disassembly of the modules beyond the level show in the exploded diagrams at the end of
this manual may result in damage to the modules and their functions.

Assembly

The assembly process is divided into pre-assembly and main assembly. First perform the
pre-assembly; then proceed to the main assembly after the components have been
assembled into units.
Perform assembly while referring to the component shapes and mounting positions shown
in the exploded diagrams at the end of this manual.
The symbols in the "Reassembly step" indicate places where checks are required. Make
sure to follow the instructions given in these places.
Circled numbers in the "Reassembly step" indicate that lubrication is required during the
reassembly of that component and that such lubrication will be difficult unless performed
during reassembly.
Refer to "Lubrication" in Chapter 4 for lubrication details on the printer module and other
modules. Also, see the lubrication diagrams at the end of this manual for the places to
lubricate.
In this assembly section, assembly steps are described as the following sequence:
Installation of the printer module (Pre-assembly A to F and Main Assembly A to L {page 3 to
29})
Installation of the other modules (Pre-assembly A to H and Main Assembly A to E {page 30
to 57})
The Main assembly A to E in the other modules' assembly is the assembly for the all pre-
assembled modules including the printer module.
6-2 Assembly and Disassembly Rev. A