Epson EU-T432 Technical Manual page 95

Confidential
Reassembly
Part name
step
5 NE detector assembly
Lead wire, NE detector × 1
6 Cover, NE detector
Wire band, SKB-85
★
C.B.S-tite (M3 × × × × 5)
7
★
C.B.S-tite (M3 × × × × 5)
8
★
cover, NE detector
Rev. A
× 1
Connect the lead wires, NE detector to the NE detector assembly.NE.
× 1
Attach the NE detector assembly to the cover, NE detector away from the
× 1
side with a screw hole.; then fasten the lead wires with a wire band.
< Check >
The fastening part should be under the bent part on the cover.
wire band SKB-85
screw hole
cover, NE detector
× 1
Attach the NE detector assembly to the frame, roll paper holder aligning
the dowels on the NE detector assembly with the grooves on the frame;
then secure the cover, NE detector with the NE detector assembly to the
frame, roll paper holder with a C.B.S-tite (M3 × × × × 5) screw.
< Check >
Tightening torque: 735 to 931mN•m {7.5 to 9.5 kg•cm}
NE detector mounting position: 6 inch type; lower, and 8 inch type; upper
× 1
Align the center of the NE detector's dowel at A on the scale gradation;
then secure the NE detector with a C.B.S-tite (M3 × × × × 5) screw.
(A: Default setting)
< Check >
Tightening torque: 735 to 931mN•m {7.5 to 9.5 kg•cm}
dowel
frame, roll paper holder
Assembly procedure
NE detector assembly
dowel on the rear side
of the NE detector
assembly
groove for 8 inch type
groove for
6 inch type
for 8 inch type
EU-T432 Technical Manual
lead wire, NE detector
groove for 8 inch type
A
groove for 6 inch type
C.B.S-tite (M3 × 5)
(for cover, NE detector)
C.B.S-tite (M3 × 5)
(for NE detector)
for 6 inch type
Assembly and Disassembly 6-35