Table of Contents
Advertisement
Confidential
Pre-assembly D
Reassembly
Part name
step
Cutter drive gear
sub-assembly
Plain washer (3 × × × × 0.5 × × × × 7) × 1
R.E. (2.5)
⑨
6-10 Assembly and Disassembly
After lubricating the shaft on the cutter cover sub-assembly with G-36,
install the cutter drive gear sub-assembly and the plain washer
on the shaft; then secure them with an R.E.
× 1
plain washer
cutter drive gear
sub-assembly
G-36
<Check>
Make sure not to apply excessive pressure to the microswitch actuator
when installing the cutter drive gear sub-assembly.
Make sure not to damage the cutter drive gear sub-assembly when
securing it with the R.E.
Lubricate the specified areas with G-36.
G-36
Assembly procedure
R.E.(2.5)
microswitch actuator
G-36
G-36
cutter motor
G-36
Rev. A
Hide quick links:
Advertisement
Table of Contents
