Epson EU-T432 Technical Manual page 37

Confidential
Make sure no dust collects on the thermal paper.
Since the printer uses a line thermal print head, condensation must be avoided. If
condensation occurs, do not turn on the printer until it has disappeared.
Do not apply excessive pressure to the lever, platen when opening or closing the platen
unit with the lever.
Cut sheet presenter module
CAUTION:
Since the paper feed motor surface will be hot after printing for a long period of time,
never touch them with your bare hands; allow about 15 minutes for them to cool.
Since the EU-T432 contains permanent magnets as well as electromagnets in the motor, they
should not be used in an environment with excessive dirt, dust and metallic dust.
Operate the cut sheet presenter module only when required. Do not apply excessive
pressure when operating the cut sheet presenter module.
Do not turn off the power during operations because that could cause a paper jam.
Control circuit board module
The serial interface is secured with inch-type hexagonal lock screws. If you need to use
millimeter-type screws, replace the inch-type screws with the millimeter-type screws enclosed
in the box.
Paper roll
Use only the recommended thermal paper because thermal paper contains a high ion
content such as Na, K and Cl may damage the head heating elements.
Avoid heat, humidity, sunlight and solvents, regardless of whether or not the paper has
been used. (Thermal paper gradually darkens at about 70°C {158°F}.)
Remove the installed paper roll when the unit is not used for a long time in a high
temperature or high humidity condition; otherwise the thermal sensitive materials
contained in the thermal paper may stick to the thermal head area, affecting the printing
quality.
Label sheets are not available for the EU-T432.
Rev. A
EU-T432 Technical Manual
Handling 3-3