Install The Telephone Handset; Rx: Install Telephone Handset (If Required); Install The Telephne Number Label; Install The Store And Forward Option - Xerox Telecopier 7017 Technical Reference Manual

Install the Telephone Handset

1. Locate the telephone handset.
2. Install the telephone handset.
b. Locate the modular jack on the lower
left side of the Terminal.
c. Insert the end of the telephone handset
cord into the modular jack.
d. Place the handset on the cradle.
3. Locate the telephone line cord.
4. Install the telephone line cord.
b. Locate the modular jack at the lower
left rear of the Terminal.
c. Insert one end of the telephone line
cord into this modular jack.
d. Insert the other end into the modular
jack at the telephone wall jack.
5. Verify telephone operation.
a. Lift handset and listen for a dial tone.
b. If no dial tone is heard, check the
connections. If checking the
connections does not resolve the
problem, refer to Service Call
Procedures.
c. Place the handset on the cradle.
Telecopier 7017 / 7017SF
RX: Install Telephone Handset (if
required)
1. Locate Customer handset.
2. Ensure appropriate connectors are fitted
to handset.
3. Locate the telephone line cord.
4. Install the telephone line cord.
a. Connect telephone line cored to L1 and
L2 on A10 Coupler.
b. Connect handset to T1 and T2 on A2
Coupler.
Install the Telephone Number Label
1. Install the telephone number label.
a. Locate the telephone number label.
b. Record the telephone number of the
Terminal on this label.
c. Remove the backing from the
protective cover.
d. Carefully place the protective cover on
the label.
e. Remove the backing from the label.
f. Locate the notch in the cradle.
g. Place the label in the notch.
12/88
www.printcopy.info
6-9

Install the Store and Forward Option

1. Install the Store and Forward Option if
ordered.
a. Remove the Store and Forward Option
from the box.
b. Remove the Right Hand Cover.
c. Position P6 Store and Forward Option
above J6 on the A2 Main and push into
position.
d. Secure the Store and Forward Option to
the front and rear frames.
e. Replace Right Hand Cover.

Install the Power Cord

1. Install the power cord.
a. Locate the power cord.
b. Plug one end of the power cord into the
receptacle at the rear of the terminal.
c. Plug the other end of the power cord
into the electrical wall outlet.
2. Verify power.
The display will momentarily indicate:
PLEASE WAIT
Telecopier 7017
and various LED's on the control panel will
light.
Installation