Xerox Telecopier 7017 Technical Reference Manual page 62

REP 4.7 Upper Printer Assembly
(continued)
CAUTION
Route LH printer pivot spring behind the wire
harness.
3. Ensure LH printer pivot spring (black) is
properly seated in both frame cutouts
and wire harnesses are properly routed.
(Figure 2)
REP 4.7, 4.8
4. Ensure RH printer pivot spring (brass) is
properly seated in both frame cutouts.
5. Reinstall and/or replace
components in reverse order. (Figure 3)
12/88
4-28
www.printcopy.info
REP 4.8 Printer Output Idler
Rollers
remaining
Parts List on PL 4.1
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. Remove upper printer assembly (REP 4.7).
7. Remove printer output idler rollers.
a. Remove all E-rings securing printer
output idler rollers.
b. Remove E-ring securing LH printer
cam bearing.
c. Remove LH printer cam bearing and
LH printer pivot spring.
d. Slide printer pivot shaft to the right
to remove printer output idler rollers.
Continued
Telecopier 7017 / 7017SF