Table of Contents
Advertisement
2.3 Status Indicator RAPS
RAP 2.3.1One Or Both LEDs of Power
Supply Are Off.
1. At least one LED is on.
Y
N
|
Go to Step 9.
2. Disconnect power cord from terminal.
Remove LH cover. Reconnect power cord
to
terminal.
Remove
fastener in upper left corner of EME
shield. Pull EME shield away from CNC
A0 PWB. Connect jumper from TP-LG to
TP41 on CNC A0 PWB (Figure 1). Both
LEDs of power supply come on.
Y
N
|
RAP 2.3.2.
TP41
TP-LG
Figure 1.
3. Replace A2. Problem resolved.
Y
N
|
Go to Step 5.
4. Go to Final Actions.
Telecopier 7017 / 7017SF
5. Replace A6. Problem resolved.
Y
N
|
Go to Step 7.
6. Go to Final Actions.
7. Replace A10. Problem resolved.
Y
N
|
Call for assistance.
8. Go to Final Actions.
9. Fuse F1 has been replaced (on this call).
black
plastic
Y
N
|
Go to Step 13.
10. Remove the power supply fuse F1. Check
fuse resistance. Meter reads less than 10
ohms.
Y
N
|
Replace power supply assembly.
11. Perform
Problem resolved.
Y
N
|
Call for assistance.
12. Go to Final Actions.
7017-107
Load
Isolation
RAP
2.3.2.
8/88
2-7
www.printcopy.info
WARNING
Improper
connection
of
conductor can result in the risk of electrical
shock. The following must be observed:
•
Never use a ground adapter plug to
connect the terminal to a power source
which
does
not
have
connection.
•
Never attempt any maintenance function
which is not specifically called out in the
service procedures.
•
Never remove any covers which are
fastened
with
screws,
instructed in the service procedures.
CAUTION
If any of the voltage measurements are not as
specified in the following steps, the cause
must be corrected. Caution the customer not
to connect the terminal to the wall outlet.
Advise the customer that a licensed electrician
must correct the wiring.
Do not attempt to
correct the wiring yourself.
If you later find
the condition has not been corrected, inform
your manager in writing of the improper
wiring.
the
grounding
a
ground
unless
so
RAP 2.3.1
Advertisement
Chapters
Table of Contents
