Rep 4.9 Cutter - Xerox Telecopier 7017 Technical Reference Manual

REP 4.8 Printer Output Idler
Rollers (continued)
Replacement
1. Reinstall printer output idler rollers.
NOTE: Reinstall the idler rollers with the
spokes on the left side and the smooth hub on
the right side.
a. Slide printer pivot shaft to the left to
reposition and hold printer output
idler rollers in upper printer frame.
b. Reposition printer
through upper printer frame.
c. Reinstall LH printer cam bearing and
secure with E-ring.
d. Reinstall all E-rings securing printer
output idler rollers.
e. Reposition LH printer pivot spring on
printer cam bearing.
2. Reinstall remaining components
reverse order.
Telecopier 7017 / 7017SF

REP 4.9 Cutter

Parts List on PL 4.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
pivot shaft
6. Remove upper printer assembly (REP 4.7).
7. Remove the cutter. (Figure 1)
a. Remove screw securing the cutter
cam.
b. Remove the two screws securing the
cutter.
Do not handle the pivoting blade on the
in
cutter. It has a sharp edge.
c. Remove the cutter.
WARNING
12/88
4-29
www.printcopy.info
Replacement
WARNING
Do not handle the pivoting blade on the
cutter. It has a sharp edge.
1. Reposition cutter.
2. Bias cutter to rear and secure with screws.
3. Reinstall remaining components
reverse order.
in
REP 4.8, 4.9