Xerox Telecopier 7017 Technical Reference Manual page 7

24. Image is full size (not reduced).
Y N
| Check wide original sensor (RAP
2.3.8); replace A2.
25. Image is parallel with paper edges (not
skewed).
Y N
| Check platen belt (RAP 2.3.11).
26. Image quality is acceptable (compare to
test pattern sample in Section 3).
Y N
| Clean platen glass; replace A2, video
assembly.
27. Set document guides for 11 inches (28
cm).
28. Place test pattern 82P151 into the ADF
face down. Reduction LED comes on.
Y N
| Check wide original sensor (RAP
2.3.8); replace A2.
29. Press Copy, then press Start. The original
is fed into the Scanner.
Y N
| Replace A2.
30. Image quality is acceptable (compare to
Wide Original sample test pattern in
Section 3).
Y N
| Clean platen glass; replace A2, video
assembly.
31. Perform 1.2.3 On-Line System Check.
Telecopier 7017 / 7017SF
1.2.3 On-Line System Check
NOTE: Perform this check only after 1.2.2 Off-
Line System Check has been performed.
NOTE: If an error code (COXX, FPXX, EXXX, or
OPXX) appears at any time during this check,
do not continue. Refer to Section 2. for the
Error Code List and perform the actions
indicated.
1. Perform a send operation to a known
good G3 facsimile terminal.
RX NOTE: If listen to dial is not permitted in
your country, go to step 3.
2. Dial tone is heard when terminal goes On
Line.
Y N
| RAP 2.3.4.
3. Dialing is completed successfully.
Y N
| Replace A10, A2.
4. Terminal transmitted in G3 mode at 9600.
Y N
| Replace A5, A2.
5. After completion of the send operation,
the display indicates:
SEND OPERATION COMPLETE
TIME
Y N
| Replace A2, A5, A10.
6. Image quality received at the remote
terminal is acceptable.
acceptance is determined by the remote
operator's perception of quality.)
Y N
| RAP 2.3.13.
12/88
1-5
www.printcopy.info
7. Call
telephone.
ready tone and the following is displayed
for approximately 3 seconds.
INCOMING CALL
TIME
Y N
| RAP 2.3.5.
8. Perform a receive operation.
receives normally at 9600 bps.
Y N
| Replace A10, A2.
9. Image quality is acceptable (refer to
Image Quality Section 3).
Y N
| RAP 2.3.13.
10. All suspect options and features have
been checked.
Y N
| Refer to Table 1 to select the
appropriate
Checks (1.3).
11. Go to Final Actions.
Table 1. Additional System Checks
#1
DATE
Suspect Option or Feature
G2 mode in send or receive
Store and forward option
(Image quality
Automatic Document Feeder
(multiple originals)
Off-Line System Check, On-Line System Check
the terminal from another
The terminal answers with a
DATE
Terminal
Additional System
Check
1.3.1
1.3.2
1.3.3