Table of Contents
Advertisement
REP 5.10 CNC PWB Assembly
(continued)
Replacement
1. Connect J120.
2. Reinstall CNC PWB assembly.
3. Ensure A0 CNC PWB is positioned in the
locating tabs on the base plate.
4. Position CNC bracket to align locating
hole and point, then secure with screw.
5. Reinstall
and/or
replace
components in reverse order.
REP 5.10, ADJ 5.1
ADJ 5.1 Cutter Registration
Purpose
The purpose is to time the cutter actuation so
that paper is cut at the trail edge of the image.
Check
1. Clean the pressure roller.
a. Open printer and remove recording
paper.
b. Clean
pressure roller using Xerox CLEAN-
remaining
UPS.
Rotate the roller to clean the
complete roller surface.
c. Reload recording paper and close
printer.
2. Enter Service Mode.
3. Print four test patterns.
a. Select Menu 61.
b. Press the Start button.
c. The test pattern will continue to print
until the Stop button is pressed. Press
the Stop button after the fourth test
pattern is cut.
d. Retain the second, third, and fourth
test patterns for step 4.
4. Verify the cutter registration.
a. Examine
fourth
horizontal lines at both the lead edge
and the trail edge.
b. Examine
fourth test patterns for a maximum
of 2 mm of white on the trail edge.
www.printcopy.info
the
exposed
area
of
the
the
second,
third,
and
test
patterns
for
five
the
second,
third,
and
12/88
4-48
c. If the printed test patterns vary by
more than 1 mm, correct the varying
registration
problem
then recheck cutter registration.
NOTE: For the next two checks, pick the test
pattern that best represents the average
position of the three test patterns.
d. If five lines are printed at lead edge
and trail edge of copy and less than 2
mm of white is on the trail edge
(Figure 2), the cutter registration is
correct.
e. If six or more lines are printed on the
lead edge and four or less lines are
printed on trail edge (Figure 1) or
more than 2 mm of white is on the
trail edge (Figure 3), perform the
cutter registration adjustment.
Adjustment
1. Perform the Check to verify that cutter
registration needs adjustment.
2. Verify that the Service mode is selected.
3.
Determine current Systems Data Setup
for cutter registration.
a. Select Menu 22 to print Options
Report.
b. Press the Start button.
c. Highlight Systems Data Setup No. 10
and the corresponding DATA.
4. Determine adjustment needed.
a. Compare the test patterns from the
cutter registration check to the test
patterns in Figures 1 through 3.
Telecopier 7017 / 7017SF
(RAP
2.3.6),
Continued
Advertisement
Chapters
Table of Contents
