Rep 4.7 Upper Printer Assembly - Xerox Telecopier 7017 Technical Reference Manual

REP 4.7 Upper Printer Assembly

Parts List on PL 4.1
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove RH cover (REP 1.2).
4. Remove coupler cover (REP 1.3).
5. Remove LH cover (REP 1.4).
6. Remove upper printer assembly. (Figure
1)
a. Cut cable tie.
b. Disconnect J114, J116, and RX: J117
from A0 CNC PWB.
c. Remove W6, W7, and RX: W8 wire
harnesses from cable clamp.
d. Remove E-rings at both ends of
printer pivot shaft.
e. Remove LH and RH printer pivot
bearings.
f. Remove printer pivot shaft from RH
frame.
g. Remove printer pivot shaft from LH
frame.
h. Remove upper printer assembly.
Telecopier 7017 / 7017SF
12/88
4-27
www.printcopy.info
Replacement
NOTE: Terminals without Tag/MOD 3 have
brass and black washers which must be
reinstalled:
• a brass washer between the LH frame
and the LH printer pivot spring,
• a brass washer between the RH frame
and the RH printer cam bearing, and
• a black washer between the LH spring
and the LH bearing.
1. Position printer pivot shaft in LH frame.
2. Position printer pivot shaft in RH frame.
Continued
REP 4.7