Handset Problems; Radio Module Or Carrier(S) - Lucent Technologies TransTalk 9000 Installation And Use Manual

Handset Problems

Symptom
After you press
There is no battery pack in
 , display
On/Off
does not show
anything.
After you press
 , the handset matching radio module.
On/Off
double beeps,
RANGE flashes in
the display, and
then the display
goes blink.
After you press
 , dial tone is
On/Off
not heard.
Possible Causes
the handset.
Battery pack is not inserted
properly in the handset.
Battery pack is not charged.
Handset is out of range of its
Serial numbers for the
handset and the radio
module do not match.
Another electrical device or
metal walls are causing
interference.
Radio module is not powered.
Telephone line cord is not
plugged into the radio
module.
The communications system
switch is not operating
properly.
Station wiring is incorrect.
Possible Solutions
Insert a battery pack in the
handset.
Reinsert the battery pack in the
handset.
Place the handset with its battery
into the handset cradle until fully
charged, or remove the handset
battery pack, and place it in the
battery charger's Spare battery
compartment until fully charged.
If you have a charged battery
pack, use it while the other
battery pack recharges.
Fully extend the handset antenna.
Move the handset closer to the
radio module.
The handset and radio module
must be a matched pair.
Remove the electrical device
that is causing interference, or
move the handset or the radio
module to another location.
Power the radio module.
Power down the radio module or
carrier(s). Wait 15 seconds. Plug
the telephone line cord into the
radio module, then repower the

radio module or carrier(s).

Check the wiring for the switch,
and verify that the switch has
power.
Check the switch manual's
station port wiring configuration.
Troubleshooting
5-5