Lucent Technologies TransTalk 9000 Installation And Use Manual page 37

Insert the carrier's AC adapter cord into the left
9
side of the carrier.
Place the carrier on its feet towards the back of
10
the shelf or desk, making sure it is in a stable
position. Be sure the telephone line cords come out the
rear exit slots in the back of the unit. Arrange the power
cord and telephone line cords beneath the shelf or
desk so no one can step on them or trip over them.
Insert the carrier's power cord into the AC
11
adapter, then plug the power cord into a
properly grounded 3-prong wall outlet that is not
controlled by an on/off switch.
If appropriate, you can wall-mount the AC adapter
using its attached wall-mounting bracket.
CAUTION:
Never connect or disconnect telephone line
cords, or insert or remove radio modules,
while the carrier is plugged into the wall outlet.
Go to "Single Carrier Installation Self Test."
2-24 Installing the MDW 9031 Pocketphone