Lucent Technologies TransTalk 9000 Installation And Use Manual page 43

Connect an expansion cable to the OUT jack of
5
the control carrier.
Insert the free end of the expansion cable into
6
the IN jack of the expansion carrier immedi-
ately to the right of the control carrier.
NOTE:
Although installing an expansion cable
into the wrong IN or OUT jack will not harm either
carrier, doing so causes all handsets to work
improperly and the OUT OF SYNC LED to light.
If you have a second expansion carrier:
7
a. Connect an expansion cable to the OUT jack
of expansion carrier #1.
b. Insert the free end of the expansion cable
into the IN jack of expansion carrier #2.
See "Key Components" earlier in this chapter for an
illustration of a four-carrier setup.
Plug an AC adapter cord into the left side of
8
each carrier.
2-30 Installing the MDW 9031 Pocketphone