Lucent Technologies TransTalk 9000 Installation And Use Manual page 83

The color of the battery charger's LEDs indicates the state of the corresponding battery
pack, as shown in the following table:
Battery charger
LED shows...
Steady orange
Steady green
Flashing red
* See note
Steady red
* Note: If either the SPARE LED or the HANDSET LED is flashing red, both battery packs
must be removed from the charger to clear the flashing-red condition. Address the possible
problems for one battery pack at a time to determine whether one is bad.
NOTE:
Before you use the MDW 9031 Pocketphone handset for the first time, the battery pack
must be charged.
3-22
Using the MDW 9031 Pocketphone
If it is the SPARE LED,
the battery pack in the
Spare battery
compartment...
Is charging
Is fully charged
Has one of the
following problems:
Is not seated
properly in the
charger
Has dirty contacts
Is defective
Is in the Discharge
portion of the Refresh
cycle.
is the HANDSET
If it
LED, the battery pack
in the Handset...
Is charging
Is fully charged
Has one of the
following problems:
Is not seated
properly in the
charger
Has dirty contacts
Is defective
Is in the Discharge
portion of the Refresh
cycle.
If it is the
REFRESH
LED, the Refresh
button was pressed,
and the Handset
battery pack...
N/A
N/A
N/A
Is in the Discharge
portion of the Refresh
cycle.