Lucent Technologies TransTalk 9000 Installation And Use Manual page 125

GENERAL (continued)
Electrical
Specifications:
(Power)
Battery Pack Life:
RF SYSTEM
PARAMETERS
Frequency Band:
Channel Spacing:
Total Channel
Capability:
Duplex Method:
Transmitter
Output Power:
Receiver
Sensitivity:
OTHER
Electrical
Requirements:
Requirements
For Out-Of-Building
Extensions:
Wiring:
C-2
Specifications
Handset
Battery Charger (BC)
Radio Module (RM)
Carrier (CA) w/6 RMs
Power Supply (BC)
Power Supply (RM)
Power Supply (CA)
Standard Nickel Metal Hydride 3 hours talk time/22 hours standby time
Extended Nickel Metal Hydride 8 hours talk time/72 hours standby time
902 – 928 MHz
150 KHz
50 (Channels Dynamically allocated out of 173)
Time Division Duplex (TDD) (Transmit and Receive on same frequency)
Dynamic Power Adjustment: 1mW ERP Minimum to 160mW ERP
Maximum
-103 dBm at Antenna Port
105 – 130VAC, 50 –60 Hz, 3-prong outlet separate ground, separately
fused at 15 amps.
Outlet must not be controlled by an on/off switch
Grounding to comply with Underwriters Laboratories (UL) 1459
Installation of a telephone or other standard (tip/ring) device in another
building requires the following In-Range Out-of-Building (IROB)
protectors to protect the switch/control unit and telephone device from
electrical surges:
MDW 9031 Pocketphone: two Lucent Technologies 146D protectors
(ETR); two Lucent Technologies 146E protectors (ATL)
MDW 9031 Pocketphone: Lucent Technologies SYSTIMAX
2-pair (4-wire) star ("home run" not "loop") ETR
Lucent Technologies SYSTIMAX or at least 4-pair (8-wire) star ("home
run" not "loop") ATL
Bridging Adapter: Lucent Technologies 267F2 (ETR)
Bridging Adapter: Lucent Technologies 267C (ATL)
Range: 1,000 feet (305 meters) for the Radio Module (26 AWG)
1.0 watt
15 watts
4.0 watts
24.0 watts
15 watts (10V 1.5 A)
6.0 watts (10V 600mA)
30.0 watts (9V)
®
or at least