Lucent Technologies TransTalk 9000 Installation And Use Manual page 103

Range Problems (continued)
Symptom
No ring on an incoming
call.
While you are talking and
walking, the handset
beeps and RANGE
flashes in the handset
display.
While you are talking
and walking, the
handset beeps and
RANGE flashes in the
handset display. You
keep walking away from
the handset's matching
radio module, the
handset double beeps
five times, the display
goes blank, and your
call appears to be
disconnected.
After placing a call on
Hold, you walk away
from the handset's
matching radio module.
Your handset beeps, the
handset display flashes
RANGE, and your call
appears to be discon-
nected.
Possible Causes
Handset is out of range of
its matching radio module.
Station wiring is
incorrect.
Radio module station
wiring is not connected
to the switch.
Station port is set to NO
RING.
Handset antenna is not
fully extended.
You are approaching an
out-of-range condition.
You are out of range of the
radio module. YOUR CALL
HAS NOT BEEN DIS-
CONNECTED. IT HAS
BEEN PLACED ON
HOLD.
You are out of range of the
radio module. YOUR CALL module. Press 
HAS NOT BEEN DISCON-
NECTED. IT IS STILL ON
HOLD.
Possible Solutions
Move the handset closer to the
radio module.
Check your switch manual for
switch settings and station wiring
diagrams.
Check your switch manual for the
correct settings.
Fully extend the handset antenna.
Move back towards the handset's
matching radio module until the
display stops showing RANGE.
Move back towards the radio
module. Press  , then proceed
On/Off
as you would for any call placed on
Hold.
Move back towards the radio
, then proceed
On/Off
as you would for any call placed on
Hold.
Troubleshooting
5-13