Lucent Technologies TransTalk 9000 Installation And Use Manual page 75

6. To determine sound clarity, listen to the simulated dial tone as you walk around.
A clear, steady tone indicates good sound clarity.
To determine signal strength, press 
7.
The display shows the signal strength (SIG) for both the handset (HS) and the base
(B) (the radio module) at the moment that 
10, as shown in the following display.
The higher the number, the stronger the signal, as shown in the following table. You
can press 
press  , you get a new reading.
1
To determine voice quality, press 
8.
The display shows the voice quality (QUAL) for both the handset (HS) and the base
(B) (the radio module) using a number from 1 to 10, as shown in the following display.
3-14
Using the MDW 9031 Pocketphone
 again to show a subsequent signal-strength reading. Each time you
1
Display Number
1 0
9
8
7
6
5
4
3
2
1
.
1
 was pressed, using a number from 1 to
1
Signal Strength Is
Strong
Strong
Strong
Very good
Very good
Good
Good to Fair
Fair
Near end of range
Near end of range/loss of link
.
2