Lucent Technologies TransTalk 9000 Installation And Use Manual page 47

Slide the telephone line cords through the cable
5
manager slot on the left front of each carrier.
Insert the free end of the telephone line cord
6
into the appropriate extension jack or terminal/
station connector on your communications system
switch/control unit (refer to your communications
system manual for the proper location).
Power the carriers as follows:
7
If the carriers are plugged into...
One surge suppressor strip
Wall outlets
CAUTION:
Never connect or disconnect expansion cables or telephone line
cords, or insert or remove radio modules, while the carrier is
plugged into the wall outlet.
Keep in mind that a Model 117A3 control carrier must have a module in Slot 6 in order to
synchronize correctly with the remaining carrier(s).
2-34
Installing the MDW 9031 Pocketphone
Then...
Power the strip.
Result: All carriers will turn on simultaneously.
Plug in the power for the Carriers in this order: