Lucent Technologies TransTalk 9000 Installation And Use Manual page 36

When the card edge is fully seated, a snap lock on
5
the bottom of the radio module will engage.
Insert a telephone line cord into the bottom of
6
each radio module.
Slide the telephone line cords through the rear
7
exit slots on the bottom of the carrier. Cords
originating from Modules 1 and 6 can share exit slots
with cords from Modules 2 and 5 respectively.
Insert the free end of the telephone line cord
8
into the appropriate extension jack or terminal/
station connector on your communications system
switch/control unit (refer to your communications
system manual for the proper location).
Installing the MDW 9031 Pocketphone
2-23