Lucent Technologies TransTalk 9000 Installation And Use Manual page 27

As the following illustration shows, each Model 117A3 carrier has two user-adjustable DIP
switches, one in Slot 2 that controls the power levels, and another in Slot 4 that specifies
whether this particular carrier is functioning as a control or an expansion carrier.
Radio
Module
Mounting
Rods
Wall Mount
Hole
Label with
Model Number
(not shown)
Power Cord
Connector
(not shown)
Card Edge
Connectors
Slot
Numbers
Wall Mount
Hole
Cable
Manager Slot
If you are installing one or more 117A3 carriers in a strip mall, high-rise office building, or
similar environment, the MDW 9031 Pocketphones may interfere with other wireless
products in use. If this is the case, you can adjust the range of the 117A3 carrier(s) to
prevent overlapping with the other wireless products.
Go to one of the following sections:
2-14
Installing the MDW 9031 Pocketphone
Power DIP
Switch
To adjust the 117A3 carrier's range, go to "Setting the 117A3
Carrier Power Level."
To skip that section, go to "Setting the 117A3 Carrier
Control/Expansion DIP switch."
Control/Expansion
DIP Switch
Radio
Module
Mounting
Rods
Wall Mount
Hole
In Jack
Out Jack
Out of Sync LED
Card Edge
Connectors
Slot
Numbers
Wall Mount
Hole
Rear
Exit Slots