Press up and hold the snap lock on the bottom
3
rear of the radio module.
Slowly swing the radio module's card edge out of
4
the card edge connector on the back of the
carrier, releasing the snap lock when clear. Unhook the
radio module from the radio module mounting rod by
gently lifting upward.
If you removed a radio module from Slot 6 of an
5
117A3 control carrier, you must insert another
radio module into this slot. Failure to do so will cause
the carriers to be unsynchronized.
Repower the carrier. If you have multiple
6
carriers, repower them in order from left to right,
as shown below:
4-2
Maintaining the MDW 9031 Pocketphone