Lucent Technologies TransTalk 9000 Installation And Use Manual page 44

Insert each carrier's power cord into its AC
9
adapter.
If appropriate, you can wall-mount each AC adapter
using its attached wall-mounting bracket.
Plug each carrier's power cord into one of the
1 0
following power sources that is not controlled
by an on/off switch.
Surge-suppressor strip.
Properly grounded 3-prong wall outlets. (See
"Wall outlets" in the following chart for the order
in which to power up the carriers.)
Power the carriers as follows:
If the carriers are plugged into...
One surge suppressor strip
Wall outlets
CAUTION:
Never connect or disconnect expansion cables or telephone line
cords, or insert or remove radio modules, while the carrier is
plugged into the wall outlet.
Then...
Power the strip.
Result: All carriers will turn on simultaneously.
Plug in the power for the Carriers in this order:
Installing the MDW 9031 Pocketphone
2-31