Lucent Technologies TransTalk 9000 Installation And Use Manual page 49

If an OUT OF SYNC LED is lit, power down,
4
wait at least 15 seconds, and then repower the
carriers in order from left to right, as described in
Step 7. If the LED is still lit, follow the suggestions in
the "Installation Problems" section of Chapter 5,
"Troubleshooting." If the LED is still lit, call for help
as described on the inside front cover of this book.
The PASS and POWER LEDs on all radio
5
modules should be lighted and green. If a radio
module's PASS LED is not lighted:
a. Power down the carriers.
b. Unplug from the wall outlet the power
cord/AC adapter of the radio module
that did not light.
c. Wait 15 seconds.
d. Plug in the radio module's power cord again.
e. Repower the carriers again, following the
proper left-to-right order.
If your LEDs match the pattern in the illustration
6
in Step 2, you can feel confident that the
carriers are cabled correctly and that the installed
radio modules are all functional. Power down the
carriers and go on to "Installing the Remaining
Radio Modules."
2-36 Installing the MDW 9031 Pocketphone