Volume And On/Off Settings For Each Partial - Roland JUPITER-80 Owner's Manual

• If a Synth Tone has been edited, a check mark (yellow) is shown
at the right of the tone name.
Volume and On/Off Settings for Each
Partial
You can turn a Partial on/off by touching the <Partial SW>.
By touching <Partial SELECT> you can select the Partial that you
want to edit.
<Partial SW> Status
Lit red On
Unlit Off
MEMO
• You can select two or more Partials by holding down the [SHIFT]
button and touching <Partial SELECT>.
• When the Synth Tone Edit screen is displayed, you can use the
PART BALANCE area of the panel to turn the three Partials on/off
and adjust their volume.
• By holding down the [SHIFT] button and pressing the PART
[PERC ON/OFF], [LOWER ON/OFF], or [UPPER ON/OFF] buttons,
you can select the Partial that you want to edit.
PART button
PART [PERC ON/OFF]
PART [LOWER ON/OFF]
PART [UPPER ON/OFF]
• To edit two or more Partials, simultaneously hold down the PART
buttons of the Partials that you want to edit.
Editing a Synth Tone
<Partial SELECT> Status
Lit green Selected
Unlit –
Controls the AMP level
of each Partial.
The AMP level of each
Partial is shown by the
level meter.
Turns each Partial
on/off.
Selected Partial
Partial 1
Partial 2
Partial 3
67