Mobile Home Requirements; Mobile Home Installation - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

Direct vent gas stove
Table of Contents

Advertisement

139894 GF 160 DV IPI 12/17

Mobile Home Installation

The GF 160 DV IPI is approved for installation in a
mobile home in the U.S. and Canada with the following
requirements:
The stove must be secured to the floor of the mobile
home. Use Jotul Floor Bracket Kit 158074.
Provision must be made to secure an electrical ground
between the stove and the mobile home chassis. Use
Jotul Floor Bracket Kit 158074.
The stove must be installed in accordance with Title 24
CFR, Part 3280-Manufactured Home Construction and
Safety Standard in the U.S.
In Canada, comply with CSA Z240.4, Gas Equipped
Recreational Vehicles and Mobile Housing.
Always contact your local officials about installation
restrictions and requirements in your area.
Leg Bracket Kit #158074
Kit Contents:
• Leg Bracket, Two
Tools & Materials:
• Power Drill / Drill Bit
• Adjustable wrench
• Lag Screw or similar fastener appropriate for the floor
construction
• Grounding wire and chassis clamp
Procedure
1. In compliance with local electrical code, install a
ground wire from the mobile home grounding to the
stove rear leg location.
2. Loosen the lower Cover Plate bolts on the rear stove
leg and engage each kit floor bracket with the bolt
head. See Fig. 17.7
3. Mark the bracket bolt hole locations on the floor and
drill floor fastener holes at those locations.
4. The ground connection may be made at either a cover
plate bolt or floor bolt.
• Secure the floor brackets to the floor with
appropriate fasteners.
• Tighten the cover plate bolts to secure the floor
brackets to the stove.
40
THIS APPLIANCE MAY BE INSTALLED AS AN OEM
INSTALLATION IN A MANUFACTURED (MOBILE)
HOME AND MUST BE INSTALLED IN ACCORDANCE
WITH THE MANUFACTURER'S INSTRUCTIONS AND
THE MANUFACTURED HOME CONSTRUCTION
AND SAFETY STANDARD, TITLE 24 CFR, PART
3280. THIS APPLIANCE IS ONLY FOR USE WITH
THE TYPE OF GAS THAT IS INDICATED ON THE
STOVE'S RATING PLATE. A GAS CONVERSION KIT
IS PROVIDED WITH THE GF 160 DV IPI GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN
AFTERMARKET PERMANENTLY LOCATED,
MANUFACTURED (MOBILE) HOME, WHERE NOT
PROHIBITED BY LOCAL CODES.
Figure 17.6
Floor Bracket installation.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents