Lighting Instructions - Jøtul GF 160 DV IPI Installation And Operation Instructions Manual

LIGHTING INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING.
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do Not try to light
the pilot by hand.
B. BEFORE LIGHTING, smell all around the appliance
area for gas.
Be sure to smell next to the floor because some gas
is heavier than air and will settle to the floor.
WHAT TO DO IF YOU SMELL GAS:
• Extinguish any open flame
• Open windows.
• Do not light this or any other appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's
phone.
• If your gas supplier cannot be reached, call the
fire department.
OPERATING INSTRUCTIONS
1. STOP! Read the safety information above.
2. Set the thermostat, if equipped, to the lowest
setting.
3. Set the Burner switch to the "OFF" position.
4. This appliance is equipped with an ignition
device which automatically lights the pilot. Do
not try to light the pilot by hand.
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the
safety information above on this label. If you
do not smell gas, go to the next step.
6. Set the Mode switch to ON for continuous pilot
operation. The pilot will light.
OR
Set Pilot to REMOTE for hand-held transmitter
control or therrmostatic operation. The pilot will
light only when there is a call for heat.
TO TURN OFF GAS TO THE APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if
service is to be performed.
WARNING:
C. Use only your hand to turn the gas control knob.
Never use tools. If the knob will not turn by hand, do
not try to force it or repair it.
Call a qualified technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified ser-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
OFF
PRG
MODE SWITCH
PILOT ASSEMBLY
7. Set the remote transmitter to the desired setting to
light the burner. If the appliance will not operate,
follow the instructions below "To Turn Off Gas To
The Appliance" and call your service technician or
gas supplier.
3. Set the Mode switch to the "OFF" position.
4. Close control access door.
REMOTE
ON
GF 160 DV IPI 12/17
43