Jøtul GF 160 DV IPI Installation And Operation Instructions Manual page 32

139894 GF 160 DV IPI 12/17
Side Glass & Gasket Replacement Kit
158080
Read through these instructions before beginning the
procedure.
Tool List:
• 10mm and 13mm sockets
• 24-in socket extension / small ratchet wrench
Replace the Side Glass Panel
1. Lift off the Top Plate. The collar grates are also loose.
2. Open the firebox. Use the Latch Tool to pull each latch
hook forward to disengage the glass frame from the
firebox. Lift the glass frame up and off of the stove.
3. Open the Control Panel under the firebox. Loosen the
Air Shutter wing nut located below the firebox floor
and push the stem back far as it will travel. See fig. 7.1,
page 15.
4. Remove the Burner: Lift the front of the burner base
to disengage it from the support brackets and pull it
forward off of the burner injector. Then tilt it side-to-
side and pull it out through the door opening. Fig. 7.2,
page 15.
5. Remove the Exhaust Baffle, (#10, fig. 17.2) from the
firebox with removal of two, 10 mm hex nuts, #11. See
also Fig. 7.3, page 16.
6. Remove the Glass Panel:
• Remove the M6 hex bolt from the upper bracket
strap at the top of the firebox. Fig. 16.2.
• Refer to fig. 16.3 and fig. 17.2 to locate the M8 hex
bolt, #7, that attaches the cast iron Side Plate to the
stove Base Plate, #40.
• Use the 13 mm socket with 24-inch extension to
loosen, but not remove, the M8 hex bolt. Loosen the
bolt enough to tilt the side plate out from the firebox
to access the two M6 nuts, #11, on the outside of the
firebox.
• Use the 10 mm socket to remove the upper and lower
outside M6 glass frame nuts.
• From inside the firebox, locate and remove the upper
and lower remaining M6 glass frame nuts, #11, Fig. 17.3.
• Remove the glass panel and frame from the firebox.
32
Gasket
Extra
Retainer Clips Glass Frame
included with
Replacement
Glass
Integrated
Retainer Tab
Figure 16.1.
Front Glass replacement.
Figure 16.2. Remove the firebox-to-side plate bolt.
Firebox
M6 Frame Nuts
Screen
Figure 16.3. View down between firebox and side plate:
Loosen the M8 Base bolt and tilt the Side Plate back to
remove the M6 glass frame nuts.
Glass Panel
M8 Base Bolt
Side Plate