Appendix; Wiring Diagram; Mobile Home Requirements - Jøtul GF 200 DV IPI Installation And Operation Instructions Manual

Appendix

Proflame 1 DFC Wiring Diagram
CPI / IPI
Switch
SPDT
Burner Switch
SPST
DC Power Supply
Figure 54. GF 200 DV IPI Proflame 1 Components
Mobile Home Installation
The GF 200 DV IPI can be installed for use in a mobile
home in the U.S. and Canada provided:
1. The stove is secured to the floor of the mobile home.
Use Jøtul Floor Bracket Kit #750304.
2. Provision must be made to secure an electrical ground
between the stove and the mobile home chassis.
3. The stove is installed in accordance with Title 24 CFR,
Part 3280- Manufactured Home Construction and
Safety Standard, in the U.S. In Canada, comply with CSA
Z240.4, Gas Equipped Recreational Vehicles and Mobile
Housing.
4. Always contact your local officials about installation
restrictions and requirements in your area.
Battery Pack
Four, 1.5v AA
THIS APPLIANCE MAY BE INSTALLED AS AN OEM
INSTALLATION IN A MANUFACTURED (MOBILE) HOME
AND MUST BE INSTALLED IN ACCORDANCE WITH
THE MANUFACTURER'S INSTRUCTIONS AND THE
MANUFACTURED HOME CONSTRUCTION AND SAFETY
STANDARD, TITLE 24 CFR, PART 3280. THIS APPLIANCE IS
ONLY FOR USE WITH THE TYPE OF GAS THAT IS INDICATED
ON THE STOVE'S RATING PLATE. A GAS CONVERSION KIT IS
PROVIDED WITH THE GF 200 DV IPI GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN AFTERMARKET
PERMANENTLY LOCATED, MANUFACTURED (MOBILE)
HOME, WHERE NOT PROHIBITED BY LOCAL CODES.
CET APPAREIL PEUT ETRE INSTALLE DANS UN MAISON
PREFABRIQUEE (MOBILE) DEJA INSTALLEE A DEMEURE SI
LES REGLEMENTS LOCAUX LE PERMETTENT. CET APPAREIL
DOIT ETRE UTILISE UNIQUEMENT AVEC LES TYPES DE
GAS INDIQUES SUR LA PLAQUE SIGNALETIQUE. NE
PAS L'UTILISER AVEC D'AUTRES GAS SAUF SI UN KITDE
CONVERSION CERTIFIE EST INSTALLE.
139587_05 GF 200 DV IPI October 2015
29