Table of Contents
Advertisement
139843_A GF 305 DV IPI 8/17
Mobile Home Installation
The GF 305 DV IPI can be installed for use in a mobile
home in the U.S. and Canada with the following
requirements:
The stove must be secured to the floor of the mobile
home. Use Jøtul Floor Bracket Kit #158038.
Provision must be made to secure an electrical ground
between the stove and the mobile home chassis. The
ground may be connected to either of the included leg
levelers.
The stove is installed in accordance with Title 24 CFR,
Part 3280-Manufactured Home Construction and
Safety Standard in the U.S. In Canada, comply with
CSA Z240.4, Gas Equipped Recreational Vehicles and
Mobile Housing.
Always contact your local officials about installation
restrictions and requirements in your area.
Procedure
1. Run a ground wire from the mobile home grounding
to the stove leg location in compliance with local
electrical code. At the stove leg, the ground may
be secured to either a Utility Cover Plate bolt, a Leg
Leveler nut or the Leg Bracket floor fastener using an
appropriate connector.
2. You can attach the Leg Bracket to a Utility Cover Plate
with the M8 x bolt provided with the stove as shown
in fig. 17.7 on the preceding page. You will
need an open end wrench.
Alternatively, it can be installed on
a Leg Leveler bolt as shown here
using the M8 hex nut provided
with the bracket.
2. Drill a pilot hole for the floor bolt
and secure the bracket to the
floor using fastener hardware
appropriate for the floor material.
44
THIS APPLIANCE MAY BE INSTALLED AS AN OEM
INSTALLATION IN A MANUFACTURED (MOBILE)
HOME AND MUST BE INSTALLED IN ACCORDANCE
WITH THE MANUFACTURER'S INSTRUCTIONS AND
THE MANUFACTURED HOME CONSTRUCTION
AND SAFETY STANDARD, TITLE 24 CFR, PART
3280. THIS APPLIANCE IS ONLY FOR USE WITH
THE TYPE OF GAS THAT IS INDICATED ON THE
STOVE'S RATING PLATE. A GAS CONVERSION KIT
IS PROVIDED WITH THE GF 305 DV IPI GAS STOVE.
THIS APPLIANCE MAY BE INSTALLED IN AN
AFTERMARKET PERMANENTLY LOCATED,
MANUFACTURED (MOBILE) HOME, WHERE NOT
PROHIBITED BY LOCAL CODES.
Kit Contents:
• Leg Bracket
• M8 Hex Nut
Tools & Materials:
• Power Drill
• 13 mm socket or open end wrench
• Lag Screw or similar floor fastener
• Grounding wire and clamp
Figure 17.9
Floor Bracket installation.
Leg Leveler
118047
M8 Hex
Nut
Leg Bracket
226248
Floor Fastener -
not supplied
Hide quick links:
Advertisement
Table of Contents
