Making System Settings - Roland SP-606 Owner's Manual

12. The message "This will clear all the internal contents. Are you sure?" will appear. Press [F3] (EXEC).
If you decide to cancel, press [F2] (CANCEL).
The display will indicate "Executing..."
13. The message "Please Power Off." will blink. Turn off the power of the SP-606, and then turn it back on
again.

Making System Settings

1.
Go to the Play screen (p. 15).
2.
Press [MENU] to get the Top Menu screen.
3.
Move the cursor to the "1:SYSTEM" line and press [ENTER].
The SYSTEM screen will appear.
4.
Press [F1] (CONFIG).
5.
Use [ ][
Turn the VALUE dial or use [DEC][INC] to set the value.
Parameter
LCD Contrast
Sampling
Grade
Metro. Mode
Metronome
Level
Preload Ptn
6.
Press [F2] (CTRL).
7.
Use [ ][
Turn the VALUE dial or use [DEC][INC] to set the value.
Parameter
Foot Sw
Assign
D Beam Sens
8.
Press [EXIT] to return to the Play screen.
You can access the SYSTEM INFO screen by holding down
[FUNC] and pressing [F1] (INFO). (p. 82)
] to select the parameter you want to set.
Value Explanation
1–16 Adjusts the contrast of the display.
STANDARD, Specifies the sampling grade.
LONG
OFF, ON, Specifies the metronome setting.
REC ONLY,
PLAY&REC
0–127 Specifies the metronome volume.
WRITABLE, Specifies whether the preloaded patterns (the patterns loaded in internal
PROTECT memory when the SP-606 is shipped) are protected.
] to select the parameter you want to set.
Value Explanation
OFF, Specifies the function of the foot switch.
START/STOP,
TAP TEMPO,
MFX1 SW,
MFX2 SW
0–127 Adjusts the sensitivity of the D Beam controller.
STANDARD: Standard audio quality.
LONG: Somewhat lower audio quality than STANDARD, but uses only
half the amount of memory.
OFF: The metronome will not sound.
ON: The metronome will always sound.
REC ONLY: The metronome will sound only while recording.
PLAY&REC: The metronome will sound during playback and recording.
WRITABLE: The preloaded patterns can be edited or erased.
PROTECT: The preloaded patterns are protected; they cannot be edited or
erased.
OFF: Not used.
START/STOP: Song or pattern playback will start/stop each time you
press the foot switch.
TAP TEMPO: The tempo will be set by the interval at which you press the
foot switch (Tap Tempo function -> p. 25, p. 66).
MFX1 SW: MFX1 will turn on/off each time you press the foot switch.
MFX2 SW: MFX2 will turn on/off each time you press the foot switch.
Chapter 12. System Settings
81