Table of Contents
Advertisement
6.
Press [F3] (SELECT) or [ENTER] to confirm your choice.
You will return to the MASTERING screen.
If you decide to cancel, press [EXIT].
Editing the Mastering Setup
7.
Use [
][
Turn the VALUE dial or use [DEC][INC] to edit the parameter value.
Parameter
Spilt Freq
In Level
Low Attack
Low Release
Low Threshold
Low Ratio
Low Level
High Attack
High Release
High Threshold
High Ratio
High Level
8.
If you want to save your settings, press [F3] (WRITE) to save them to "1 USER SET."
9.
The display will ask "System Write, Are You Sure?" To save your settings, press [F3] (EXEC) or [ENTER].
If you decide not to save your settings, press [F2] (CANCEL) or [EXIT].
List of Effects
MFX
1 FILTER + DRIVE
This is a low pass filter with
overdrive. It cuts the high-fre-
quency range and adds distor-
tion.
2 REVERB
This is a reverb that cuts the re-
verb sound midway through
its decay.
3 DELAY
This is a stereo delay
4 TAPE ECHO
This simulates a classic tape-
type echo unit.
5 ISOLATOR
Isolates or eliminates the low,
mid, or high-frequency re-
gions.
] to select the parameter you want to edit.
Value
Explanation
200–8000Hz
Frequency at which the High and Low ranges are divided
-24–0dB
Mastering input volume
0.05–50ms
Time over which compression is applied to the volume after the input exceeds the
Low Threshold
0.05–2000ms
Time over which compression is released after the input falls below the Low
Threshold
0–127
Volume level at which compression begins to be applied to the low frequency
range
1:1–inf:1
Compression ratio for the low frequency range (inf: infinite)
-24–+24dB
Output volume of the low frequency compressor
0.05–50ms
Time over which compression is applied to the volume after the input exceeds the
High Threshold
0.05–2000ms
Time over which compression is released after the input falls below the High
Threshold
0–127
Volume level at which compression begins to be applied to the high frequency
range
1:1–inf:1
Compression ratio for the high frequency range (inf: infinite)
-24–+24dB
Output volume of the high frequency compressor
CTRL 1
CUTOFF
Adjusts the frequency at which
the sound will be cut.
REV TIME
Adjusts the length of the rever-
beration.
DLY TIME
Adjusts the delay length (*2)
REPEAT
Adjusts the tape speed.
LOW
Isolates/eliminates the low-
frequency range.
CTRL 2
RESO
Adjusts the amount of peak
(boost) applied to the region of
the cutoff frequency.
HF DAMP
Adjusts the frequency at which
the high-frequency portion of
the reverb is cut.
FEEDBACK
Adjusts the proportion of the
delayed sound that will be re-
turned to the input.
INTENS
Adjusts the number of echo re-
peats.
MIDDLE
Isolates/eliminates the mid-
frequency range.
Chapter 2. Using Effects
CTRL 3
DRIVE
Adds distortion.
E.LEVEL
Adjusts the volume of the re-
verb sound.
E.LEVEL
Adjusts the volume of the de-
lay sound.
E.LEVEL
Adjusts the volume of the echo
sound.
HIGH
Isolates/eliminates the high-
frequency range.
35
Advertisement
Table of Contents
