Table of Contents
Advertisement
Chapter 9. Using the D Beam
Using the D Beam Controller
The D Beam is a controller that you use simply by moving your hand above it. Three different ways of using the D
Beam are already set up for immediate use; trigger, synth, and filter. By adjusting the D Beam settings you can use
it to apply a wide range of other effects.
Press [TRIGGER], [SYNTH], or [FILTER] to turn on one of the D Beam settings; the button will light. The button
will go out when you turn it off.
The Range of the D Beam Controller
The effective range of the D Beam controller is shown in the diagram below. No effect will occur if
you move your hand outside this range.
D Beam Controller Settings
Basic Procedure for Making D Beam Settings
1.
Go to the Play screen (p. 15).
2.
Press [MENU] to get the Top Menu screen.
3.
Press [
[ENTER].
The D BEAM SETTING screen will appear.
4.
Use [
][
Press [F1] (TRIG) to edit trigger-related parameters.
Press [F2] (SYNTH) to edit synth-related parameters.
Press [F3] (FILTER) to edit filter-related parameters.
Hold down [FUNC] and press [F1] (INFO) to get the D BEAM INFO (D Beam Information) screen.
5.
Turn the VALUE dial or use [DEC][INC] to edit the parameter value.
6.
If you want to save the changes you made, hold down [FUNC] and press [F3] (WRITE) to save the
parameter values.
7.
Press [EXIT] to return to the Play screen.
72
You cannot simultaneously turn on more than one of these three buttons.
The effective range of the D Beam controller will be severely reduced if used in strong,
direct sunlight. Be aware of this when using the D Beam controller outside.
] to move the cursor to "2:D Beam Setting" and press
] to select the parameter you want to edit.
Advertisement
Table of Contents
