Roland SP-606 Owner's Manual page 94

MIDI Implementation
■System Realtime Message
●Timing Clock
Status
F8H
* This message is transmitted only if Tx MIDI Sync is ON.
●Start
Status
FAH
* This message is transmitted only if Tx MIDI Sync is ON or during EXT SEQ
SAMPLING.
●Continue
Status
FBH
* This message is transmitted only if Tx MIDI Sync is ON or during EXT SEQ
SAMPLING.
●Stop
Status
FCH
* This message is transmitted only if Tx MIDI Sync is ON or during EXT SEQ
SAMPLING.
●Active Sensing
Status
FEH
■System Exclusive Message
●Universal Non-realtime System Exclusive
Messages
❍Identity Reply
Status Data byte
F0H 7EH, 10H, 06H, 02H, 41H,F7H
6EH, 01H, 00H, 00H,
00H, 02H, 00H, 00H
Byte Explanation
F0H Exclusive status
7EH ID number (universal non-realtime message)
10H Device ID
06H 02H Identity Reply
41H ID number (Roland)
6EH 01H Device family code
00H 00H Device family number code
00H 02H 00H 00H software revision level
F7H EOX (End Of Exclusive)
●Data set 1 (DT1)
Status Data byte
F0H 41H, 10H, 00H, 6EH, 12H,F7H
aaH, bbH, ccH, ddH, eeH,...
ffH, sum
Byte Explanation
F0H Exclusive status
41H ID number (Roland)
10H Device ID
00H 6EH Model ID (SP-606)
94
Status
Status
12H Command ID (DT1)
aaH Address MSB
bbH Address
ccH Address
ddH Address LSB
eeH Data: the actual data to be sent. Multiple bytes of data are
transmitted in order starting from the address.
: :
ffH Data
sum Checksum
F7H EOX (End Of Exclusive)
3. Parameter address map
■Addresses Transmitted and Received When
Switching to EXT Mode
The following address is transmitted and received when switching to EXT mode.
Address Description
00 00 00 00 EXT Control mode
Data (Value)
0 (OFF),
1 (ON/PART SELECT),
2 (ON/MUTE),
3 (ON/SOLE),
4 (ON/SEQ TRIGGER),
5 (ON/NOTE TRIGGER)