Roland XV-88 Owner's Manual page 77

Start (Portamento Start Pitch)
Portamento will begin anew if you press another key during
a pitch movement. This setting specifies the pitch at which
the change will begin.
PITCH: When another key is pressed while the pitch is
moving, portamento will begin anew from the pitch that had
been reached at that moment.
fig.05-35.e
Pitch
C5
D4
C4
press D4 key
press C5 key
press C4 key
NOTE: Portamento will begin anew from the pitch where the
current change would end.
fig.05-36.e
Pitch
C5
D4
C4
press D4 key
press C5 key
press C4 key
CTRL Rx MIDI (Control Receive MIDI)
fig.05-37
fig.05-38
Here you can specify for each Tone how MIDI messages such
as pitch bend, expression and pan will be received.
• Generally, pitch bend messages control the pitch of the
currently sounding note, expression messages control
the volume. In addition to this, the XV-88 allows these
MIDI messages to be used to control Tone settings or
Multi-effects settings as well (p. 78, p. 115). If you are
using this capability, turn reception of these MIDI
messages OFF. If the receive switch is ON for these
messages, they will control their usual function (in
addition to their special function).
• When assigning (and playing) a Patch to a Part in a
Performance, check the MIDI message settings for each
MIDI channel (p. 52). If the MIDI channels for that part
are set not to receive MIDI messages, then the MIDI
messages will not be received.
Time
Bender (Receive Pitch Bend Switch)
Specifies whether Pitch Bend messages will be received (ON)
or not (OFF).
Expression (Receive Expression Switch)
Specifies whether Expression messages will be received (ON)
or not (OFF).
Pan Mode (Receive Pan Mode)
Specifies how Pan messages will be received.
CONTINUOUS: Whenever Pan messages are received, the
stereo position of the Tone will be changed.
KEY-ON: The pan of the Tone will be changed only when the
next note is played. If a pan message is received while a note
Time
is sounding, the panning will not change until the next key is
pressed.
The channels cannot be set so as not to receive Pan
messages.
Hold-1 (Receive Hold 1 Switch)
Specifies whether Hold 1 messages will be received (ON) or
not (OFF).
If NO SUSTAIN is selected for Envelope Mode
parameter (PATCH/CONTROL/CTRL Rx MIDI), this
setting will have no effect.
Chapter 5. Creating Patches
77