Roland XV-88 Owner's Manual page 135

28: OVERDRIVE DELAY
This effect connects an overdrive and a delay in series.
fig.MFX-28
L in
Overdrive
R in
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
OD Pan (Overdrive Pan) #
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
DlyTime (Delay Time)
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Dly Fbk (Delay Feedback Level)
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Delay HF Damp
Adjust the frequency above which delayed sound fed back to
the effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Delay Balance (Delay Balance) #
Adjust the volume balance between the overdrive sound that
is sent through the delay and the overdrive sound that is not
sent through the delay. With a setting of "D100:0W," only the
overdrive sound will be output. With a setting of "D0:100W,"
only the overdrive sound that is sent through the delay will
be output.
Level (Output Level)
Adjust the output level.
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
Chapter 7. Adding Effects
29: DISTORTION CHORUS
This effect connects distortion and chorus in series. The
parameters are essentially the same as "26:
OVERDRIVE CHORUS," with the exception of the
following two.
OD Drive Dist Drive (Specify the amount of distortion.)
OD Pan Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-29
L in
Balance D
Distortion Chorus
R in
Balance D
30: DISTORTION FLANGER
This effect connects distortion and flanger in series. The
parameters are essentially the same as in "27:
OVERDRIVE FLANGER," with the exception of the
following two.
OD Drive Dist Drive (Specify the amount of distortion.)
OD Pan Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-30
L in
Distortion
R in
31: DISTORTION DELAY
This effect connects distortion and delay in series. The
parameters are essentially the same as in "28:
OVERDRIVE DELAY," with the exception of the following
two.
OD Drive Dist Drive (Specify the amount of distortion.)
OD Pan Dist Pan (Specify the stereo location of the
distortion sound.)
fig.MFX-31
L in
Distortion
R in
L out
Balance W
Balance W
R out
Balance D
L out
Feedback
Balance W
Flanger
Balance W
R out
Balance D
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
135