Roland XV-88 Owner's Manual page 139

38: CHORUS/DELAY
This effect connects a chorus and a delay in parallel. The
parameters are the same as for "35: CHORUS DELAY."
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
fig.MFX-38
Balance D
L in
Chorus
Feedback
Delay
R in
Balance D
39: FLANGER/DELAY
This effect connects a flanger and a delay in parallel. The
parameters are the same as for "36: FLANGER DELAY."
However, the Delay Balance parameter adjusts the volume
balance between the direct sound and the delay sound.
fig.MFX-39
Balance D
L in
Flanger
Feedback
Feedback
Delay
R in
Balance D
40: CHORUS/FLANGER
This effect connects a chorus and a flanger in parallel. The
parameters are the same as for "37: CHORUS FLANGER."
However, the Flanger Balance parameter adjusts the volume
balance between the direct sound and the flanger sound.
fig.MFX-40
Balance D
L in
Chorus
Feedback
Flanger
R in
Balance D
L out
Balance W
Balance W
R out
L out
Balance W
Balance W
R out
L out
Balance W
Balance W
R out
Chapter 7. Adding Effects
41: STEREO PHASER
This is a stereo phaser. With the Step effects, you can also
make stepped changes in the pitch of sounds to which the
Phaser effect is applied.
fig.MFX-41
L in
Phaser
Mix
Mix
Phaser
R in
Type (Phaser Type)
Selects the type of Phaser.
Type 2 adds more of the Phaser effect to the high frequencies
than Type 1.
Mode
Selects the number of stages in the phaser (4/8).
Pol (Polarity)
Selects whether the left and right phase of the modulation
will be the same or the opposite.
INVERSE: The left and right phase will be opposite. When
using a mono source, this spreads the sound.
SYNCHRO: The left and right phase will be the same. Select
this when inputting a stereo source.
Man (Manual) #
Adjusts the center frequency to which the phase effect is
applied.
Rate (Phaser Rate) #
Adjust the frequency of modulation.
Rate parameter can be set as a note-value of a specified
tempo. In this case, specify the value of the desired note.
When Rate is Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88's system
(p. 169).
Depth (Phaser Depth)
Adjust the depth of modulation.
Res (Phaser Resonance)
Adjust the amount of feedback for the phaser. Higher
settings will give the sound a stronger character.
2-Band
L out
EQ
2-Band
R out
EQ
139