Roland XV-88 Owner's Manual page 187

You can specify the data to be transmitted by selecting the
appropriate combination shown below.
For example, if you wish to transmit only the PR-A group
Patch 001, specify "PATCH PR-A:001-001."
If the selected data is too large to fit completely into the
transmission destination, as much of the data as will fit
will be transmitted, starting at the first number of the
specified transmission destination.
(Example)
Type PATCH
Block PR-A:001–005
Destination User:127
If the above settings are made and transmission is
executed, only the two PR-A group Patches 01 and 02
will be transmitted to USER group Patches 127 and 128.
Type Block
ALL PR-A, B
PERFORM USER
PR-A, B
CARD
PATCH USER
PR-A–F
XP-A–D
CARD
RHYTHM USER
PR-A–F
XP-A–D
CARD
SYSTEM Card
F-LIST Card
*1 There are no Performances except in PR-A and B; no
selection is available.
*2 Data is moved within the User Memory as a block, and
Performances, Patches, and Rhythm Sets are overwritten.
*3 After specifying a file number, set the range of the block to be
transmitted.
*4 Data in PR-H is GM data, and so cannot be transmitted.
*5 Depends on the Wave Expansion Board installed.
*6 Specify a file number.
Chapter 10. Memory Settings (Utility Mode)
*1
01–64 *2
01–32 *1
** *3
001–128 *2
001–128 *4
001–*** *5
** *3
001–004 *2
001–002 *4
001–*** *5
** *3
** *6
** *6
Type (Data Type)
Specifies the type of data to be transmitted.
ALL: Performance, Patch, and Rhythm Set
PERFORM: Performance
PATCH: Patch
RHYTHM: Rhythm Set
SYSTEM: System
F-LIST: Favorite List
Block (Source Block)
Specifies the source of the data to be transmitted.
USER: Data from user memory will be transmitted.
PR-A–F: Preset A–F data will be transmitted.
XP-A–D: Data from an Wave Expansion Board will be
transmitted.
XP-A–D can be selected only if the corresponding Wave
Expansion Board is installed.
CARD: Performance/Patch/Rhythm Set/Favorite List data
stored on memory card will be transmitted.
fig.10-28.e
Destination
This is the Transmission destination. It is set with User.
If the Type parameter has been set to PERFORM,
PATCH, or RHYTHM, you must specify the first
memory location number of the transmission
destination.
File number File name
187