Roland XV-88 Owner's Manual page 123

Level (Output Level) #
Adjust the output level.
09: COMPRESSOR
The Compressor flattens out high levels and boosts low
levels, smoothing out unevenness in volume.
fig.MFX-09
L in
Compressor
R in
Attack
Adjust the attack time of an input sound.
Sustain
Adjust the time over which low level sounds are boosted
until they reach the specified volume.
Post Gain
Adjust the output gain.
LowGain (Low Gain)
Adjust the low frequency gain.
Hi Gain (High Gain)
Adjust the high frequency gain.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Level (Output Level) #
Adjust the output level.
L out
Pan L
2-Band
EQ
Pan R
R out
Chapter 7. Adding Effects
10: LIMITER
The Limiter compresses signals that exceed a specified
volume level, preventing distortion from occurring.
fig.MFX-10
L in
2-Band
Limiter
R in
Thresh (Threshold Level)
Adjust the volume at which compression will begin.
Ratio (Compression Ratio)
Adjust the compression ratio.
Release (Release Time)
Adjust the time from when the volume falls below the
Threshold Level until compression is no longer applied.
Gain (Post Gain)
Adjust the output gain.
LowGain (Low Gain)
Adjust the low frequency gain.
Hi Gain (High Gain)
Adjust the high frequency gain.
Pan (Output Pan) #
Adjust the stereo location of the output sound. L64 is far left,
0 is center, and 63R is far right.
Level (Output Level) #
Adjust the output level.
L out
Pan L
EQ
Pan R
R out
123