Roland XV-88 Owner's Manual page 144

Chapter 7. Adding Effects
46: REVERSE DELAY
Reverse Delay is a delay effect that adds the reverse of the
input sound as the delay sound.
fig.MFX-46
L in
Feedback
Rev. Delay
R in
Delay 1 (Delay Time 1)
Adjust the delay time from the direct sound until the delay 1
sound is heard.
Delay 2 (Delay Time 2)
Adjust the delay time from the direct sound until the delay 2
sound is heard.
Delay 3 (Delay Time 3)
Adjust the delay time from the direct sound until the delay 3
sound is heard.
Delay 4 (Delay Time 4)
Adjust the delay time from the direct sound until the delay 4
sound is heard.
Delay 1–4 parameters can be set as a note-value of a
specified tempo. In this case, specify the value of the
desired note.
When Delay 1–4 are Set as a Note Value
As the specified tempo, you may use either the Patch
Tempo (p. 71) or the tempo clock of the XV-88's system
(p. 169).
Feedback 1:4 #
Adjust the proportion (%) of the delay 1 and 4 sound that is
fed back into the effect. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp 1:4
Adjust the frequency above which delayed sound (Delay 1,
4) fed back to the delay input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
144
2-Band
EQ
1
D1
D2
Delay
2
D3
D4
3
2-Band
EQ
Thr (Threshold Level)
Specify the volume level at which the reverse delay will
begin to apply.
Pan 1:2:3 (Output Pan 1:2:3)
L out
Adjust the pan of delay sound (Delay 1–3). A setting of L64 is
far left, 0 is center, and 63R is far right.
Level 1:2:3
R out
Adjust the output level of delay 1, 2 and 3.
LowGain (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
Hi Gain (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance (Effect Balance) #
Sets the volume balance between the direct sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Level (Output Level)
Adjust the output level.