Omron 3G3MX2 Series User Manual page 28

Item
Commands Program control com-
mands
Arithmetic commands
I/O control
Timer control
Parameter control
Inverter control
Function variable User parameter vari-
able
Internal user variable
Frequency reference
variable
Acceleration time vari-
able
Deceleration time vari-
able
Inverter monitor vari-
able
Multi-function input
variable
Drive Programming User's Manual (I580-E2)
• Loop ("for")
• Unconditional branch ("goto")
• Time control ("wait")
• Conditional branch ("if then", "ifs then", "select case", "until", "while")
• Subroutine ("call", "sub")
• Others ("entry", "end", "inc", "dec")
• Four arithmetic operations (, , *, and /)
• Remainder ("mod") and assignment ()
• Absolute value ("abs")
• Logical operations ("or", "and", "xor", "not")
• Multi-function I/O (bit input, word input, bit output, and word output)
• Reads inverter input terminals
• Reads/writes inverter output terminals
Contacts control by timer and timer counter control
• Changes setting data of specified parameter number
• Saves parameter setting data in EEPROM
RX only: current time reading (once/continuous)
• Executes and stops forward/reverse operation
• Generates a trip by the Drive Programming (E50 to E59/10 points)
• Frequency reference and acceleration/deceleration time settings
U(00) to U(31)/32 points
UL(00) to UL(07)/8 points
SET-Freq
ACCEL
DECEL
The monitor functions (d001 to d102) for the inverter are available as vari-
ables.
MX2 and RX:
FM, Iout, Dir, PID-FB, F-CNV, Tmon, Vout, Power, RUN-Time, ON-Time,
POS, STATUS, DCV, ERR-CNT, ERR(1) to ERR(6), and UMon(0) to
UMon(2)
The function options of the Multi-function Input S1 Selection (C001) for the
inverter are available.
MX2 and RX:
FW, RV, CF1, CF2, CF3, CF4, JG, DB, SET, TCH, FRS, EXT, USP, CS, SFT,
AT, RS, STA, STP, F-R, PID, PIDC, UP, DWN, UDC, OPE, SF1, SF2, SF3,
SF4, SF5, SF6, SF7, OLR, TL, TRQ1, TRQ2, BOK, LAC, PCLR, ADD, F-TM,
ATR, KHC, AHD, CP1, CP2, CP3, ORL, ORG, and SPD
MX2 only:
RS485, HLD, ROK, and DISP
RX only:
SET3, CAS, PPI, ORT, STAT, SON, FOC, FOT, ROT, PCNT, and PCC
2 Specifications
Specifications
2
2 - 3