Omron 3G3MX2 Series User Manual page 156

 Example: (when you save only F002 in the EEPROM)
In the above example, the parameter F002 is changed to the value of U(02) and saved in the EEPROM.
F003 is changed to the value of U(03), however, it is not saved in the EEPROM.
Block number
1 Sets to save the data in the EEPROM for the following "ChgParam" command.
2 Assigns U(02) to the parameter F002. The data is also saved in the EEPROM because the "eep-
wrt" command is executed immediately before this command.
3 Assigns U(03) to the parameter F003. This value is not saved in the EEPROM.
4 Jumps to the block 1: loop_ unconditionally.
Drive Programming User's Manual (I580-E2)
Flowchart
Operation
6 Drive Programming Commands
Text
6
6 - 55