Omron 3G3MX2 Series User Manual page 163

6 Drive Programming Commands
Trip
Command
Generates the inverter trip.
The inverter stops when it detects a trip.
Note 1. Even if an inverter trip occurs in one task, the Drive Programming program does not stop the other
possible tasks in the program, and the processing is continued.
2. You can set 10 or greater values by using any variable and constant (up to 127), however, even if a
trip occurs, the displayed error code will always be E59.
 Example
In the above example, a user trip occurs in the inverter when the input terminal variable X(01) is set to
ON.
Block number
1 Operates the inverter in the forward direction.
2 If X(01) is 0, jumps to the block 5: jmp. If X(01) is not 0, the program goes to the next step.
3 Generates the user trip 1 in the inverter.
4 Stops the inverter.
5 Jumps to the block 1: loop_ unconditionally.
6 - 62
Description
Flowchart method
trip <value>

Flowchart
Value: any variable or constant
(range 0 to 9)
0 to 9 correspond to the alarm code E50 to E59.
Format
Text language method
trip <value>
Operation
Drive Programming User's Manual (I580-E2)
Argument
Text