Setting Infeed Guide; Setting Guide Plate - Grizzly G0825 Owner's Manual

Setting Infeed Guide

The infeed guide controls the height of the edge-
banding tape to ensure it gets applied flush with
the top of the workpiece. In order to function
properly, the infeed guide must be set at the same
height as the guide plate, which slides across the
top of the workpiece during operation.
Guide
Scale
Infeed
Guide
Figure 14. Infeed guide adjustment components.
The numbers on the guide scale correspond to
the edgebanding width (in millimeters). Adjust the
infeed guide to the correct edgebanding width.
Model G0825 (Mfd. Since 02/17)
Infeed-Guide
Lock Knob

Setting Guide Plate

The guide plate is adjustable for both height and
angle.
During operation, the guide plate slides across
the top of the workpiece to help ensure tape is
applied evenly and flush with top edge. The guide
plate height must be set to match the workpiece
thickness.
For typical operations, the guide plate must also
be set 90° to the feed rollers. Specific operations
may require adjusting the angle of the guide plate
(see Figure 15). The angle is shown on the scale
at the base of the guide-plate post. The angle
scale allows the guide plate to be accurately
adjusted to +/-15°.
+/-15
o
Figure 15. Infeed guide adjustment components.
Guide Plate
Workpiece
-19-