Table of Contents
Advertisement
Setting Guide Plate Angle
Tools Needed
Precision Square ............................................... 1
Hex Wrench 6mm .............................................. 1
To set guide plate angle 90º to feed roller:
1.
With one hand, place precision square even
with face of outfeed roller and across outfeed
side of base plate (see Figure 16).
2.
With free hand, loosen guide-plate lock lever
(see Figure 16), and lower guide plate evenly
onto precision square, then retighten lock
lever.
3.
Loosen lock screw (see Figure 16), and
adjust guide plate angle until it sits flush
along precision square.
Lock Screw
90º
Precision Square
Figure 16. Squaring guide plate.
4.
Tighten lock screw and re-check to confirm
setting.
5.
Calibrate angle scale pointer/scale plate to 0º
by loosening Phillips head screws, adjusting
scale plate, then retightening screws.
-20-
Setting Guide Plate Height
Qty
The guide plate must be adjusted to allow top
edge of edgebanding tape to align flush to top of
workpiece. Use the guide-plate height scale (dis-
played in millimeters) to set the guide plate.
Note: For smooth feeding, add a few millime-
ters to your measurement to allow clearance for
adjustments in Step 3. This can easily be done
by putting an appropriately thick piece of paper on
workpiece when setting guide plate.
Note: Always ensure guide plate lock is properly
secured before operation.
To set height of guide plate:
1.
Lock
Lever
Angle
Scale
Guide Plate
2.
Place guide plate on top of workpiece, then
move edgebander toward workpiece until
feed roller and baseplate contact workpiece
edge, as shown in Figure 17.
Note: If necessary, raise or lower the
guide plate to allow outfeed rollers to reach
workpiece.
Guide Plate
Lock Lever
Outfeed Roller
Base Plate
Figure 17. Guide plate adjusted for workpiece
height.
Retighten guide-plate lock lever to secure
setting.
Model G0825 (Mfd. Since 02/17)
Guide Plate
Advertisement
Table of Contents
