Table of Contents
Advertisement
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide a basic
understanding of how the machine is used during
operation, so the machine controls/components
discussed later in this manual are easier to under-
stand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of injury from entangle-
ment, lung damage, or from contacting hot
surfaces, always take appropriate safety
precautions when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model G0825 (Mfd. Since 02/17)
manual
BEFORE
To complete a typical operation, the operator
does the following:
1.
Examines/prepares the workpiece to make
sure it is suitable for edgebanding, and
ensures area around workpiece is clear of
tripping hazards.
2.
Loads edgebanding coil onto coil support.
3.
Turns master power switch ON, sets glue
temperature, and presses heating unit ON/
OFF button on control panel to begin heating
glue pot.
4.
Adjusts infeed guide plate until it just touches
top of edgebanding.
5.
Adjusts amount of glue being applied to edge-
banding by turning glue adjustment knob on
top cover after glue is fully heated.
6.
Adjusts angle and height of guide plate
according to thickness/bevel of workpiece.
7.
Rests guide plate on top of workpiece and
starts feed rollers.
8.
Feeds edgebanding into feed roller, and
moves edgebander along workpiece edge
while maintaining firm pressure against
workpiece. Adjusts feed rate with feed dial.
9.
Stops feed roller when banding is applied to
entire workpiece edge, then cuts edgeband-
ing.
10. Presses heating unit ON/OFF button on con-
trol panel to switch glue pot to storage mode.
Note: Indicator light will illuminate beside
storage symbol (
be stored. Light indicates when glue pot tem-
perature falls below 140°F (60°C).
11. Turns master power switch OFF and unplugs
edgebander.
)when edgebander may
-17-
Advertisement
Table of Contents
