Adjusting Laser Guide - Grizzly T33959 Owner's Manual

Adjusting
Laser Guide
The laser guide should be checked and adjusted
for accuracy when you change drill bits, raise
or lower the table, or change the workpiece
thickness.
DO NOT look directly into laser. Eye injury
may result.
Tool Needed
Phillips Head Screwdriver #1 ............................ 1
To adjust laser guide:
DISCONNECT MACHINE FROM POWER!
1.
Install drill bit in chuck (see Installing/
2.
Removing Drill Bit on Page 29).
Clamp workpiece to table.
3.
Adjust table so workpiece is just below drill
4.
bit, then lock table in position.
Lower bit so it touches workpiece, making
5.
slight indentation in surface, then raise bit.
Connect drill press to power. Use laser switch
6.
to turn laser guide ON (see Figures 46–47).
Figure 46. Location of T33959/T33960 laser
switch.
-34-
Qty
Laser Switch
Figure 47. Location of T33961 laser switch.
— If laser crosshairs align with indentation
you made in Step 5 (see Figure 48), no
adjustment is necessary.
— If laser crosshairs do not align with inden-
tation you made in Step 5 (see Figure
48), proceed to Step 7.
Figure 48. Example of laser crosshairs aligned
with indentation on workpiece.
Loosen (2) Phillips head screws shown in
7.
Figures 49–50, then adjust laser modules
by hand, positioning them so crosshairs align
with indentation you made in Step 5.
— Turning each laser module will adjust each
crosshair line angle.
— Adjusting laser module position in seat will
adjust crosshair line positions.
Model T33959/60/61 (Mfd. Since 08/23)
Laser Switch